[email protected]
86-18692697905
English
English
| Mellanox Compatible: | MFS1S00-V001E | Vendor Name: | Fibercoms | Connector Type: | QSFP56 to QSFP56 |
| Max Data Rate: | 200Gbps | Cable Length: | 3m-50m | Minimum Bend Radius: | 30mm |
| Cable Type: | OM3 | Jacket Material: | LSZH | Transmitter Type: | VSCEL |
| Receiver Type: | PIN | Modulation Format: | PAM4 | DDM/DOM Supported: | Yes |
| Operation Temperature: | 0 to 70°C (32 to 158°F) | Protocols: | IEEE 802.3, QSFP56 MSA, SFF-8665, SFF-8636 | Warranty: | 3 Years |
The 200G QSFP56 active optical cable is designed for use in 200Gb/s Ethernet (200GbE) systems. It contains four multi-mode fibers optical transceivers per end, each operating at data rates of up to 50Gb/s. It enables higher port bandwidth, density and configurability at a low cost and reduced power requirement in the data centers. This cable is compliant with IEEE 802.3, SFF-8665, SFF-8636, QSFP56 MSA.
Absolute Maximum Specifications
| Parameter | Min | Max | Units |
| Supply voltage | -0.3 | 3.6 | V |
| Data input voltage | -0.3 | 3.465 | V |
| Control input voltage | -0.3 | 4.0 | V |
| Damage Threshold | 3.4 | - | dBm |
Operational Specifications
| Parameter | Min | Typ | Max | Units |
| Supply voltage (Vcc) | 3.135 | 3.3 | 3.465 | V |
|
Power consumption (each end, retiming on all lanes) |
- | 4.35 | 4.55 | W |
| Supply noise tolerance (10Hz-10MHz) | 66 | - | - | mVpp |
| Operating case temperature | 0 | - |
70 1
|
°C
|
| Operating relative humidity | 5 | - | 85 | % |
1. Internal temperature readout through DDMI of up to 75°C is allowed.
Electrical Specifications
| Parameter | Min | Typ | Max | Units |
| Signaling rate | -100ppm | 53.125 | +100ppm | GBd |
| Differential data input swing at TP1a | TBD | - | 900 | mVpp |
| Differential data output swing at TP4a | - | - | 900 | mVpp |
| Near-end ESMW | 0.265 | - | - | UI |
| Near-end output eye height | 70 | - | - | mVpp |
| Output transition time, 20% to 80% | 9.5 | - | - | ps |
1. Multiple clock domains are supported only on line-side Rx. Host side Rx supports a single clock domain only.
2. QSFP Tx CDR lock can only occur if Tx lane 4 is transmitting data.
Key features:
200GbE Data Rate
4x 50Gb/s PAM4 modulation
Single 3.3V power supply
Up to 100m length
Hot pluggable
RoHS compliant
Shenzhen Fibercoms Co., Ltd
Phone:
86-18692697905
Email:
[email protected]
Address:
Hubei road, Dongmen Street, Luohu District, Shenzhen, China
